pppd
pppd
The pppd
command in Linux is used to establish and maintain a Point-to-Point Protocol (PPP) connection. PPP is a protocol that is used to establish a connection between two devices over a serial link.
The syntax for the pppd
command is as follows:
pppd [options]
The following are some of the most useful pppd
options:
-c
: Specify a configuration file.-d
: Debug mode.-i
: Interface to use.-m
: Modem device.-P
: Password.
Here is an example of how to use the pppd
command to establish a PPP connection to a remote server:
pppd -c /etc/ppp/peers/remote-server
This command will attempt to establish a PPP connection to the remote server using the configuration file /etc/ppp/peers/remote-server
. If the connection is successful, the pppd
command will create a virtual interface called ppp0
.
The pppd
command is a useful tool for establishing and maintaining PPP connections. It can be used to connect to remote servers, access the internet, and transfer files.
Here are some of the benefits of using the pppd
command:
It can be used to connect to remote servers.
It can be used to access the internet.
It can be used to transfer files.
It can be used to troubleshoot problems with PPP connections.
If you are using PPP on your system, you should make sure to learn how to use the pppd
command. It is a valuable tool for establishing and maintaining PPP connections and for troubleshooting problems with them.
help
pppd version 2.4.9
Usage: pppd [ options ], where options are:
<device> Communicate over the named device
<speed> Set the baud rate to <speed>
<loc>:<rem> Set the local and/or remote interface IP
addresses. Either one may be omitted.
asyncmap <n> Set the desired async map to hex <n>
auth Require authentication from peer
connect <p> Invoke shell command <p> to set up the serial line
crtscts Use hardware RTS/CTS flow control
defaultroute Add default route through interface
file <f> Take options from file <f>
modem Use modem control lines
mru <n> Set MRU value to <n> for negotiation
Last updated